GYS NEOPULSE 270-T1 Manual De Instrucciones página 24

Spool Gun torch (OPTION)
Procedure of reel assembly on
Spool Gun torch
5
RESET
Save:
SD card with version V1005 allows using synergic welding for the material and diameters in the chart below:
24
NEOPULSE 270-T1 / 270-T2 / 300
ONLY FOR THE NEOPULSE 270-T2
The Spool Gun torch is connected to the connector (7). This torch can be
used only in synergic, standard and manual mode.
- In manual mode (see p.20), the knob to adjust the wire speed is on the
torch (adjustment cannot be done on the machine).
- In synergic mode (see p.20), the adjusting knob enables to amend the
wire speed between 50% to 100% of the interface value.
The detection of the Push-Pull torch is made by a simple press on the trig-
ger. Make sure to adjust the max speed wanted with the dial on the inter-
face.
1- Button opening/closing casing
2- Reel tightening nut
3- Reel break nut (do not tighten too much)
4
4- Adjsutment screw for rollers tension
5- Adjustment knob for speed wire
- Open the case (1), remove the support nut (2).
- Untighten the reel brake nut (3).
- Insert your reel.
- To insert the wire in the rollers, put a tension on the «adjustment screw for rollers
tension (4)»
3
1 2 - Remove the torch wire by reeling the reel.
- Plug in the Spool gun command connector and power connector (see p.2).
The NEOPULSE has 2 reset options. The « SOFT » option resets the machine
completely but stores the settings saved in memory. The « TOTAL » option
reset the machine perameters to those when purchased (For this mode an SD
card is needed).
To save a welding program you need to enter a number and a name. (7
letters) In the event of use with several torches, select the torch used before
getting back the memory.
EN