Troubleshooting - GYS NEOPULSE 270-T1 Manual De Instrucciones

4 times pulse process
I
T hotstart
Dstart
4T
Soft-start
In 4T Pulse, the trigger will manage the time of the Hotstart and downslope.
SD card

TROUBLESHOOTING

SYMPTOMS
The welding wire speed is not
constant.
The wire-feeder motor doesn't operate.
Bad wire feed.
NEOPULSE 270-T1 / 270-T2 / 300
T upslope
The SD card allows the operator to save the original settings. An SD card
should ALWAYS be used when undertaking a « total » reset.
After resetting the parameters and to avoid the upload of these ones each
time you switch on your machine, push the SD card in order to remove it.
By this way, the card stays in the machine but it can't be read.
Password:
The password by default is: 0000.
In case of loss, the super user password allows you to unlock the unit:
MORWAS
To reactivate the standard password (0000), you need to reset completely
the machine. Read paragraph « reset ».
POSSIBLE CAUSES
Debris is blocking up the opening.
The wire skids in the rollers.
The wire skids in the rollers.
The torch lead is twisted.
Reel or roller brake too tight.
Electrical supply problem.
Covering wire guide dirty or
damaged.
Roller axle key missing
Reel brake too tight
T downslope
T burn-back
4T
REMEDIES
Clean out the contact tip or change it and
replace the anti-adherence product.
- Check the roller pressure or replace it.
- Wire diameter incompatible with roller
- Covering wire guide in the torch
incompatible.
Check and tighten the roller's screws.
The torch lead must be as straight as
possible.
possible.
Check that the power switch is in the «On»
position.
Clean or replace
Reposition the key.
Adjust the brake
EN
I Blackout
Gas post-Flow
27