Setting The Treble Control; Setting The Treble Center Frequency; Setting The Treble Level; Setting The Bbe Mode - Alpine CDA-9856 Manual De Operación

Bass level indicator's display
Bass Level is usually displayed. When BBE is activated,
the display changes according to the BBE setting.

Setting the Treble Control

You can change the Treble Frequency emphasis to create your own tonal
preference.
1
Press MENU to select the BASS ENGINE mode, then
press MODE.
BBE BASS ENGINE
2
Press or to select the TREBLE (Treble
Center Frequency) control mode.
BASS TREBLE

Setting the Treble Center Frequency

3
-1 Press SOURCE/POWER to select the desired treble
center frequency.
10.0kHz 12.5kHz 15.0kHz
Emphasizes the displayed treble frequency ranges.

Setting the Treble Level

3
2
-2* Turn the Rotary encoder to select the desired
treble level (–7~+7).
You can emphasize the treble frequency.
4
Press MENU to select RETURN.
After 2 seconds, the unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
• If no operation is performed within 60 seconds, the treble control
setting will be turned off automatically.
• The treble level settings will be individually memorized for each
source (FM, AM, CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, AM, CD, etc.).
• Depending on the connected devices, some functions and display
indications do not work. However, Treble Level is still adjustable if
an audio processor with the Treble function is connected.
• This function is inoperable when DEFEAT is set to ON.
• While in the treble adjusting mode, BASS CONTROL adjusting mode
can be recalled by pressing
2
* The adjustment can also be made by pressing MODE. Refer to
"Adjusting Bass/Treble/Balance (Between Left and Right)/Fader
(Between Front and Rear)/Defeat" (page 13).
14
-EN
SETUP RETURN (OFF)
7.5kHz 10.0kHz
or .

Setting the BBE Mode

BBE makes vocals or instruments sound distinct regardless of the music
source. The FM radio, CD, and MP3, will be able to reproduce the
music clearly even in cars with a lot of road noise.
1
Press SOURCE/POWER to select the source to
which you want to apply BBE.
2
Press MENU to select BBE mode, then press
MODE.
BBE BASS ENGINE
3
Press
BBE OFF*
4
Turn the Rotary encoder to select your preferred
BBE level (1 to 3) or EFFECT OFF.
5
Press MENU to select RETURN.
BBE
After 2 seconds, the unit returns to normal mode.
Pressing and holding MENU for at least 2 seconds will
return to normal mode.
* To cancel BBE mode for all music sources, press
OFF in step 3.
• Each music source, such as FM radio, CD (included MP3/WMA) can
have its own BBE setting.
• This function is inoperable when DEFEAT is set to ON.
• There is no BBE mode for AM radio.
• When an external audio processor is connected, this setting cannot
be made.
• If no operation is performed in 60 seconds, the unit returns to normal
mode.
SETUP RETURN (OFF)
to set the BBE mode ON.
BBE ON
(BBE 1 to 3, EFFECT OFF)
BBE
to select BBE