Installation Instructions - Festo CPV GE-ASI-8E8A CE Serie Instrucciones Para El Usuario

3

Installation instructions

3.1 AS−Interface addresses
Before connecting to the AS−Interface bus: assign an
unused address to each slave.
Note
Valve terminal type CPV...−GE−ASI−8E8A−Z−M8−CE
contains 2 AS−Interface slaves. The valve terminal
behaves on the AS−Interface bus like two individual
valve terminals each with 4 inputs and 4 outputs
(valve solenoid coils).
Assignment of the inputs and outputs (valves):
slave 1:
slave 2:
Automatic addressing with the function Automatic
address assignment" of the master is not possible.
It is not necessary to parametrize the AS−Interface
slaves.
Address assignment
The assignment of the data bits to the inputs and outputs
of both independent slaves is shown in the following
diagram.
Data bits:
Inputs:
Outputs:
I/O = Bidirectional (B)
The address mapping depends on the configuration of the
master.
Festo CPV...−GE−ASI−8E8A−...−CE 0703NH English
inputs I0
inputs I4
Slave 1: IO code 7
D0 D1 D2 D3
I/O I/O I/O I/O
I0 I1 I2
O0 O1 O2 O3
I3; outputs O0
I7; outputs O4
Slave 2: IO code 7
H
D0 D1
I/O I/O
I3 I4 I5
O4 O5
O3
O7.
H
D2 D3
I/O I/O
I6 I7
O6 O7
17