M O D E L S I C B 4 2 4
A N D
L O C K
I N S TA L L AT I O N
IMPORTANT NOTE: If you are adding an
accessory lock kit to your Wine Storage unit,
it should be installed before you position the
unit. Installation instructions are included with
the lock kit.
For Model ICB424, the lock is attached to the
bottom of the metal door frame. The decora-
tive door panel is not involved in the installa-
tion or operation of the lock. The catch portion
of the lock is attached to the bottom of the
appliance cabinet in pre-punched holes. When
installing the lock kit, it may be helpful to tip
the unit on its back for easier access.
P O S I T I O N
T H E U N I T
IMPORTANT NOTE: If for any reason the Wine
Storage unit has been laid on its back or side,
you must allow the unit to stand upright for
a minimum of 24 hours before connecting
power.
Plug the power supply cord into the 10 amp
grounded electrical outlet. With power applied
to the appliance, check for lighting and cooling
before going any further. Once you are satis-
fied that the unit is operating properly, shut
off power to the electrical outlet at the circuit
breaker and proceed.
Shut off the power to the electrical outlet.
I C B 4 2 4 F S
I N S TA L L AT I O N
If a home alarm system is to be used with the
Wine Storage unit, the lead wires should be
threaded into the compressor compartment
before you position the unit. See Home Alarm
Connections on page 8, for the location of
these lead wires. After the unit is in position,
the alarm wiring can be completed from the
front.
Pre-level the Wine Storage unit before sliding
it into position. Leveling cannot be completed
with the unit pushed back in the installation
opening.
For Model ICB424FS, adust the leveling legs
so the top of the unit is no more than 879 mm
above the floor. This is to allow the unit to
engage the anti-tip bracket properly. Center the
Model ICB424FS in front of the anti-tip bracket.
Slide the unit into position, making sure the
anti-tip bracket is engaged properly.
IMPORTANT NOTE: When the Wine Storage
unit is installed, the anti-tip bracket will be
positioned just below the engaging bracket
on the unit. It is not necessary to raise the
unit up so that it locks into the anti-tip bracket,
but the unit must be in alignment with the
anti-tip bracket.
The Wine Storage unit provides the best
access to its contents when the front surface
of the door panel extends out from surround-
ing cabinets approximately 6 mm. For Model
ICB424FS, if there are no surrounding cabinet
surfaces to gauge depth, slide the unit back
until it engages the anti-tip bracket.
IMPORTANT NOTE: The floor under the Wine
Storage unit must be at the same level as the
surrounding finished floor to allow for removal
of the unit for servicing.
M O D E L S
I C B 4 2 4
I C B 4 2 4 F S
7