Release Of The Automation - V2 ATRIS Manual Del Usuario

9. Only for sectional and spring operated garage doors
Fasten the draw slide P on the upper portion of the door
Connect the perforated bar Q and the bent arm R using 2
bolts 6x15 and their relative nuts. Connect the curved arm R
and the draw plate P using the cylindrical headed pivot with
the provided split pin.
R
P
I
10. Only for counter-weighted garage doors
Fasten the arch arm 162504 on the upper portion of the door
maintaining the previously marked reference points.
The two anchor plates (upper and lower) of the arch 162504
must be in the same plane. If not, add shims.
Connect the perforated bar Q to the perforated arm of the
bow-arm S using 2 bolts 6 x 15 and their relative nuts.
Q
Q
L
S

7 - RELEASE OF THE AUTOMATION

In order to release the automation from inside, pull the knob
downwards.
Then, accompany the gate manually throughout its path.
m
CAUTION: Do not use the knob to open the door.
It is prohibited to hand objects off the release cord.
If there are no secondary accesses to the garage we
recommend the installation of the device to unlock from the
outside (code 162518)
m
WARNING: If the door is unlocked to be opened,
when it will be closed it is automatically locked for security
reasons.
If the power supply is not available, the door can be
opened only by acting again on the release knob.
In order to release the automation from outside, install the
accessory release kit (code 162518).
- 29 -