Vollrath VBBC1-37-A Manual Del Usuario página 9

TROUBLESHOOTING
Problem
It takes too long for the beverage to
chill to desired serving temperature.
Product is leaking from the machine. Bowl may not be properly seated on the
Condensation on the bowl(s).
Beverage not circulating well.
(Stirring Paddle and Agitator
machines)
Refrigerated Beverage Dispensers Operator's Manual
Might be Caused By
Beverage was not chilled before pouring it
into the bowl.
Airflow is blocked.
Condenser fins may be dirty.
Impeller may be dirty or need to be
lubricated.
Impeller may be damaged.
gasket. Gasket may be installed incorrectly.
Rubber washer on the spigot may be
installed incorrectly.
Gasket or rubber washer may be worn or
damaged.
The ring on the piston hole in the bowl may
be dirty, worn or damaged.
Ambient temperature is too warm or
humidity is too high.
Beverage may be too thick.
Impeller may be dirty or need to be
lubricated.
Impeller may be damaged.
Course of Action
Chill beverages before pouring into the bowl.
Machine does not have enough clearance or the environment is
not correct. See CLEARANCE AND ENVIROMENT
REQUIREMENTS.
Refer to CLEAN THE CONDENSER in this manual.
Inspect the impeller for food debris. Verify the impeller can
freely rotate. If it cannot, then apply a food grade lubricate to the
washer located on the underside of the impeller.
Replace the impeller.
Drain the bowl and reassemble the machine. See ASSEMBLE
THE MACHINE.
Drain the bowl. Remove the spigot. Verify the rubber is installed
with the wider portion at the top. See ASSEMBLE THE
MACHINE.
Replace the component.
Drain the beverage from the bowl. Remove the bowl and inspect
the piston hole at the bottom of the bowl for debris or wear.
Cool the environment or relocate the machine.
Add liquid to thin the beverage.
Turn off and unplug the machine. Remove the impeller from the
bowl. Remove any food debris from the impeller or surrounding
area. Food debris could impede the operation of the impeller
and beverage circulation.
Replace the component.
9