ABB EuroFlex MN1926WEN Guía De Instalación Rápida página 10

10 Quick Installation Guide – EuroFlex

DIP switches
The DIP switches form a 4-bit binary pattern (with switch 4 as the
most significant bit), allowing the values 0-15 to be selected.
This value represents the node ID that will be used by the
EuroFlex for unique identification on a network.
The EuroFlex is capable of storing up to four configuration
parameter sets. The value selected by the DIP switches also
represents which of the parameter sets (0-3) will be used. Since
there are only four parameter sets, selecting values greater than
3 will cause parameter set 0 to be selected.
The DIP switches are read at power up, so must be adjusted
before applying power. When a switch is on (pressed down) the
bit is active (1).

Tightening torques
All screw terminal
connections
Start-up
See manual MN1926WEN.
N·m (lbf·in)
0.2 - 0.25 (1.8 - 2.2)
S1
4
3
2
1