Configuration Through Memory Card; Memory Card Creation/Update; Configuration Loading From Memory Card; Loading Default Values - Pixsys ATR244-12ABC Manual De Instalación

maximum/decimals limits (for numeric parameters), included the text description (as per section n. 11
of the user manual). Once selected the chosen value, the related row will be updated and underlined
into the tab "DATA" (hold down the line to cancel modifications).
To download the new configuration on your device, select the third tab "WRITE", place again the
smartphone in contact with the controller and wait for the notification.
The ATR244 will show a restart request, necessary to update the configuration with the new written
modifications; if it does not restart, the ATR 244 will continue to work with the previous configuration.
In addition to the classic operation of parameters reading->modification->writing, MyPixsys is
provided with additional functions which can be accessed by the tab "EXTRA", as save parameters /
e-mail loaded values/ restore default values.
10.1

Configuration through memory card

The device can be configured through a memory card (2100.30.013). This one is linked to the micro-USB
connector on the bottom of the device.
10.2

Memory card creation/update

ATR244
C1
C2 A1 A2 A3 TUN MAN REM
FNC SET
10.3

Configuration loading from memory card

ATR244
C1
C2 A1 A2 A3 TUN MAN REM
FNC SET
11

Loading default values

This procedure allows to restore factory settings of the device.
Press Display
FNC Display 1 shows
1
for 3 sec shows
Modify the flashing digit
2 and move to the next one
c or d
pressing SET.
FNC The device loads default
3
to confirm settings and restarts.
32 - ATR244 - User manual
In order to save a parameter configuration in the memory card, connect it to
micro-USB connector and power the instrument. If the memory has never
been configured, the device starts normally, but if its data are considered
valid, it is possible to view on the display
the product without uploading any data from the memory card. Configure,
set the parameters and exit configuration. Now, the device saves the
configuration just created also in the memory.
In order to charge a configuration previously created and saved in the
memory card, connect it to the micro-USB connector and power the
instrument. Now, if the memory is detected and its data are considered valid,
it is possible to view on the display
and with SET you confirm the uploading of parameters from the memory
Load
card to the controller. If, on the other hand, you press directly SET, when
viewing , the product starts without uploading any data from the
Memo skip
memory card.
, while display 2
PASS,
with the 1st digit flashing.
0000
. Press
memo skip
. By pressing
memo skip
Do
Enter password
9999
SET in order to start

you see
Memo
.