Confirmation Beep; Viewing Optional Displays - MSA ALTAIR 5 Manual De Instrucciones

MSA
To Charge the Instrument
Firmly insert the charger connector into the charge port on the back of
•
the instrument.
An LED in the battery pack is used to indicate on the charge status.
•
Red = charging, Green = charged, Amber = fault
If a problem is detected during charging (LED turns amber).
•
Disconnect the charger momentarily to reset the charge cycle.

2.3.4 Confirmation Beep

This confirmation beep activates every 30 seconds by momentarily beeping
the horn and flashing the alarm LEDs under the following conditions:
Confirmation beep is enabled
•
Instrument is on normal Measure Gases page
•
Instrument is not in battery warning
•
Instrument is not in gas alarm.
•
2.4.

Viewing Optional Displays

The Main Screen appears at instrument turn-ON.
Optional displays can be viewed by pressing the
screen as indicated by the "soft key".
(For the monochromatic display the name of the page is displayed, for the
color version it is represented by an icon.)
2.4.1 Peak Readings (PEAK page)
Monochromatic display
This page shows the highest levels of gas recorded by the instrument since
turn-ON or since peak readings were reset.
To reset the peak readings:
(1) Access the PEAK page.
(2) Press the
2.4.2 Minimum Readings (MIN page)
Monochromatic display
This page shows the lowest level of oxygen recorded by the instrument
since turn-ON or since the MIN reading was reset.
To reset the MIN readings:
(1) Access the MIN page.
(2) Press the
US
PEAK
button.
MIN
button.
ALTAIR 5 - Operating Manual
DESCRIPTION
button to move to the
Color display
Color display
17