Maintenance - Omron Gentle Temp 522 PRO Manual De Instrucciones

4. Troubleshooting and Maintenance
Error Display
Temperature taken is higher than 42.2°C
(108.0°F).
Temperature taken is lower than 34.0°C
(93.2°F).
Unit cannot be powered on to ready stage.
4.2

Maintenance

• Check the unit if it is dropped. If unsure, please contact the OMRON retail outlet or distributor for having the unit checked.
• The probe is the most delicate part of the unit. Use care when cleaning the probe lens to avoid damage. When
the probe lens becomes dirty, wipe it lightly with a soft dry cloth or a cotton swab.
• If the unit is accidentally used without the probe cover, clean the probe as follows:
a.After measurement, use a cotton swab moistened with alcohol (70% concentration) to clean the probe and probe lens.
b.Allow at least 1 minute for the probe to fully dry.
• If the unit is dirty, use a cotton swab or cloth moistened with alcohol (70% concentration) to clean it.
• Do not store the unit in the following types of places. Doing so may damage the unit.
- Wet locations.
- Locations with high heat and humidity or those that are exposed to direct sunlight. Areas close to heating
equipment, dusty locations, or environments where there are high salt concentrations in the air.
- Locations where the unit will be subjected to leaning over, falling, shock, or vibration.
- Locations where corrosive gases are present.
- Pharmaceutical storage areas.
14
Cause Remedy
Check the integrity of the probe cover and take a new
temperature measurement.
Make sure the probe cover is clean and take a new
temperature measurement.
Change to a new battery.
(Refer to section 4.3)