To Define The Upper And Lower Movement Limits - Kinetec Centura B&W Manual De Empleo

Using the hand control

To define the upper and lower movement limits

• At the start of a session
This function, MANUAL MODE, allows the maximum limits that a patient can tolerate to be defined and recorded at the beginning of a
session.
Set up the patient and proceed as below:
Beginning
Switch the unit ON
To select
MANUAL MODE
To set the pain level when reached, press
To set the lower limit
To set the pain level when reached, press
To start the session with the new movement limits
• During the session
This function, BYPASS MODE, allows the maximum limits that a patient can tolerate to be defined and recorded, which allows you to
work on increasing amplitude.
Beginning
The unit is running
To select
BYPASS Mode
To set the NEW pain level when reached, press
To set the lower limit
To set the NEW pain level when reached, press
Continue the session with the NEW movement limits.
Comments:
• The values in the display column are given as an example.
Kinetec Centura B&W™
Keys to press
KINETEC
Centura B&W V01.0
Movement verif
Please wait
ARM STRAIGHT
0 Stop
continuously press
ARM STRAIGHT
0 Manual
ARM STRAIGHT
0 Manual 15
continuously press
ARM STRAIGHT
0 Manual
ARM STRAIGHT
15 Manual 15
ARM STRAIGHT
15 Run
Keys to press
ARM STRAIGHT
15 Run
continuously press
ARM STRAIGHT
15 bypass
ARM STRAIGHT
15 bypass
continuously press
ARM STRAIGHT
15 bypass
ARM STRAIGHT
5 bypass
ARM STRAIGHT
5 RUN
15/24
Display
Check that the hand control is not locked (See
page 9).
20 110
The unit starts moving to the upper limit of the
movement.
65 110
The settings are controlled by you.
The new upper limit of the movement is
65 recorded.
The unit starts moving to the lower limit of the
15 65
movement.
The new lower limit of the movement is
65
recorded.
The angle display changes with the current
15 65 movement.
Display
Check that the hand control is not locked (See
15 65
page 9).
The unit exceeds the recorded upper limit.
80 65
The new upper limit of the movement is
80 80
recorded.
The unit starts moving to the lower limit of the
5 80
movement.
The new lower limit of the movement is
5 80
recorded.
The angle display changes with the current
5 80 movement.
Remarks
Remarks
EN