Storing The Keypad In The Central Unit And Storing The Badge In The Keypad; Customising System Operation - SOMFY 2401241 Manual De Instrucciones

Storing the keypad in the central unit and storing the
badge in the keypad
See the main instructions for your alarm system to enter storage mode at the central unit.
1
You now have 2 minutes to press
...BEEP! at the central unit confirms that the central unit has stored the keypad.
2
Pass the badge in front of the keypad reception area:
To store a 2 badge, repeat the same operation.
nd

Customising system operation

All the settings described in this section can be modified much more easily if you have an
LCD keypad or the computer interface. In this case, ignore this section.
All the codes to be stored must be between 0001 and 9998.
If your installation includes an LCD keypad then the installer and user codes on the control
keypad will automatically be identical to those present in your system. We recommend that
you note them down.
To customize a parameter, you must first enter the installer menu by typing the code:
2 2 2 2 #
(default code)
Next, you have 2 minutes to type the command to modify the parameter. The phone dialer indicates
whether this command has been accepted:
Command...
Example of the modification of the installer code:
2 2 2 2 #
(default code)
You have 2 minutes to enter the new installer code XXXX by typing:
2 0 X X X X
4
on the keypad.
➜ BEEP!
at the phone dialer
■
➜ BEEP!
at the phone dialer
■
BEEPs!
series of
➜ ■
X X X X #
BEEP!
the code is correct
➜ ■
the parameter has been
➜ ■
stored
the action is not confirmed
➜ ■
➜ BEEP!
at the
■
phone dialer
➜ BEEP!
at the
■
phone dialer
BEEPs!
series of
➜ ■
Copyright © 2015 Somfy SAS. All rights reserved.
the code is correct
➜ ■
the code is correct
➜ ■
the code is
➜ ■
incorrect