Maintenance; Maintenance Schedule; Battery Maintenance; Troubleshooting - Nilfisk-Advance Advolution 24BT 220AH Instrucciones Para El Uso Y Lista De Piezas

EN
ENGLISH

MAINTENANCE

MAINTENANCE SCHEDULE

Maintenance Item
Charge Batteries
Check/Replace Dust Bags
Check/Replace Skirt
Clean Pad
Lubrication
Check/Service Pad Motor Brushes
Service Drive Motor Brushes

BATTERY MAINTENANCE

Charge the batteries each time the machine is used for 1 hour or longer, or
whenever the Battery Meter reads in the red area.
To Charge the Batteries...
1 Remove cover.
2 Plug charger in.
3 Check the fluid level in all battery cells after charging the batteries. Add
distilled water, if necessary, to bring the fluid level up to the bottom of the filler
tubes.
CAUTION!
To avoid damage to floor surfaces, wipe water and acid
from the top of the batteries after charging.
CAUTION!
Acid can spill onto the floor if the batteries are overfilled.
IMPORTANT
Motor damage resulting from failure to service carbon
brushes is not covered under warranty. See the Limited
Warranty statement.
8 - FORM NO. 70523A - Advolution 24B, 24BT
Daily Monthly Yearly
x
x
x
x
x
x
x

TROUBLESHOOTING

MACHINE VIBRATION

1 Pad is not centered properly.
2 Defective pad. Replace.

SWIRL MARKS

1 Pad is too aggressive for the floor finish.
2 Pad is dirty, Check and replace.

REDUCED RUNNING TIME

1 Battery needs to be charged.
2 Batteries need water. Add just enough to cover the plates in each cell. Then
charge the batteries and check the water level again.
(E) PAD ASSIST MACHINE DOES NOT PULL
ITSELF
For pad assist adjustment, follow the steps below (see steps 1 - 6 in Figure
E):
1 Tip burnisher back as shown to gain access to the pivot bracket.
2 Remove the dust bag.
3 Pull down on the dust skirt to gain access to the adjustment hardware.
4 Lossen pivot bracket adjustment hardware and pivot bolts and rotate bracket
counterclockwise to increase pad assist.
5 Pivot braket has slots to allow adjustment.
6 Adjust pivot bracket so pad is tipped down towards the RH side of the
machine to increase the pad assist. Then retighten the adjustment hardware.
CAUTION!
Pad assist will vary depending on the aggressiveness of
pad and the floor finish. If the deck is angled too much it
could result in the pad burning the floor on the RH side.