Publicidad
Idiomas disponibles
Idiomas disponibles
Installation du circuit de freinage – suite
Vue éclatée No 5 :
• Serrer les bras de frein
afi n que les patins
de frein
soient contre la jante.
Vue éclatée No 6 :
• Tendre à fond le câble du frein
• Serrer l'écrou du câble
.
• Régler l'écrou du câble
afi n d'obtenir un
écart de 1/16 po (1,5 mm) pour le patin de frein.
1/16"
1/16"
(1.5 mm)
Vue éclatée No 7 :
• Vérifi er que la poignée du frein n'est pas lâche
20
5
5-1
5-2
.
6
7
0
.
Seat Installation - continued
WARNING
post can loosen while riding. This can cause injury to the rider or to others.
Tighten the quick release lever (fi g C):
1.
Open and close the Quick Release Lever with one hand while you turn the Adjusting Nut
H
with the other hand.
2.
Tighten or loosen the adjusting nut by hand, so that you fi rst feel resistance to the quick
release lever when it perpendicular to the bicycle frame.
3.
Push the Quick Release Lever to the "close" position.
4.
When in the "close" position, make sure the Quick Release Lever lays against the Seat
Post Clamp
5.
The tightening torque of the Quick Release Lever should be tight enough so that the
seat does not move during normal operation.
Seat Bolt Mount (various models)
Some models have a Bolt
6-3
J
Washer
and Nut
of a Quick Release Lever.
6-2
• If needed, loosen the nut
enough to insert the Seat
E
Post
.
6-1
• Point the seat forward and
insert Seat Post to the Mini-
mum Insertion marks
• Tighten Nut securely so it
supports the rider without
moving.
7-1
: If the clamping force of the Quick Release Lever is too light, the seat
G
.
I
,
B
K
instead
I
B
.
E
K
C
J
fig D
13
Publicidad
Capítulos
