Ice and Water Dispenser
To dispense water or ice: select Water, Crushed, or Cubed.
Press the glass gently against the
top of the dispenser cradle.
The drip tray is not self-draining.
To reduce water spotting, the
shelf and its grille should be
cleaned regularly.
the refrigerator is first installed,
there may be air in the water
line system. Press the dispenser
cradle for at least two minutes to
remove trapped air from the water
line and to fill the water system.
To flush out impurities in the water line, throw away the
first gallon (3.8 liters) of water.
Ice Storage Drawer on Dispenser Models
To remove:
Lift up the access door to reach the icemaker. Set the
icemaker power switch to the OFF position. With the
access door closed, support the storage bin at the
bottom while slightly lifting. Pull bin straight out.
Important Facts About Your Dispenser
may not crush or dispense well.
Backed-up ice can jam the chute or cause the door in the
through with a wooden spoon.
ice storage bin. Cans, bottles or food packages in the
storage bin may cause the icemaker or auger to jam.
glass close to, but not touching, the dispenser opening.
selected Cubed. This happens occasionally when a few
cubes have been left in the crusher.
6
(On some models.)
CAUTION
objects into the ice crusher discharge opening.
Locking the Dispenser:
Press Settings menu for Control Lock and select ON. To
unlock, press Settings menu for Control Lock and select
OFF.
Light:
This feature turns the light on and off. The light also
comes on when the dispenser cradle is pressed.
Drip Tray
To replace:
Slide the bin back until the tab on the bin locks into the
push the bin back again.
the chute.
in the ice chute. This condition is normal and usually
occurs when you have dispensed crushed ice repeatedly.
The snow will eventually evaporate.
the following ones. This is normal.
add crushed ice or cubes before dispensing water.
slightly when dispensing water.
Never put fingers or any other
Rotate
Drive
Mechanism
49-1000364 Rev. 1