Feeding In The Wire En - Abicor Binzel ABIDRIVE V2 Instructivo De Servicio

TIG cold-wire feeder
6.4.5 Feeding in the wire
The wire can be fed in using buttons (8) and (9) on the front panel
 Fig. 6 Function type selection on page EN-13
or the rocker. As a prerequisite, function F5 must be preset to A or C. The wire feed-in rate on the welding
torch handle is set using function F4.
If feeding in the wire using a soft start, function F3 must be set. The wire feed then starts slowly at a rate of
0.5 m/min. After two seconds, the feed rate increases to the rate set in F4.
The applicable parameter settings can be found in the following table:
Function Description
T2 Rocker
F3 Soft start for wire feed
F4 Wire feed rate
Tab. 16 Wire feed settings
Fig. 13
Explanation of the setting process
Switch the wire feed on or off
 Tab. 10 Display indicators for advanced functions on page EN-14
 Tab. 10 Display indicators for advanced functions on page EN-14
Button
or
Torch
T1 T3
Motor
F3=OFF
Motor
F3=ON
t (sec)=1.5*F4
t=2 sec
h=0.5 m/min
Feeding in the wire
6 Putting into operation
h (m/min)=F4
h (m/min)=F4
ON
OFF
m/min
m/min
EN - 19