Connecting The Torch And The Welding Device - Abicor Binzel ABIDRIVE V2 Instructivo De Servicio

TIG cold-wire feeder

6.11 Connecting the torch and the welding device

The wire feeder can be controlled using an appropriate standard torch.
Fig. 18
Fig. 19
The welding power source can be optionally triggered by the start welding signal from the wire feeder. The
signal occurs via pins 1+2 (X2).
 6.4.4 4-cycle and interval with torch for controlling the power source via the feed on page EN-18
If welding is started via pins 1+2, the wire feed and welding process can both be started using rocker T2
on the welding torch. This mode is recommended for automated welding as the wire feed and the welding
process can be started via one signal.
For manual welding, the welding process is started using the separate torch trigger.
 Fig. 18 Standard torch activates the power source via pins 5+6 on page EN-25
Power on
Wire on
T2
T4
T1 T3
Up wire Down wire
Standard torch activates the power source via pins 5+6
F5=A
Start wire feed
Wire feed
Wire retraction
F5=b
Start wire feed
UP wire speed
DOWN wire speed
F5=C
Start wire feed
UP wire feed
DOWN wire retraction
6 Putting into operation
Control lead
(shielded)
BN
GN
WH
GY
PK
YE
n.c.
n.c.
n.c.
n.c.
T1 = 1+3
n.c.
T2 = 1+2
n.c.
T3 = 1+4
n.c.
Neutral
T4 = 5+6
X1
1 KDW S
2
T2
3
T1
4
T3
X1
1 KDW S
2
T2
3
T1
4
T3
X1
1 KDW S
2
T2
3
T1
4
T3
Amphenol con
14-pin
2
6
5
3
4
1
7
8
9
10
11
12
13
14
EN - 25