Assembling Procedure - Optika B-510 Serie Manual De Instrucciones

Assembling procedure

1. Insert the optical head above the stand and
tighten the screw. (Fig.1)
► Hold the head with one hand during
the locking in order to avoid that the
head falls.
2. Insert both eyepieces into the tubes of the
optical head. (Fig.2)
3. Condenser is pre-installed in the factory.
To remove the condenser use an Allen
wrench 1,5mm diam and operate on the
locking screw placed on the right side of the
condenser holder.
4. Screw each objective into the thread of
the nosepiece, clockwise with increasing
magnification. (Fig.3)
5. Insert the power supply jack in the connector
placed at the rear side of the microscope.
(Fig.4)
DO NOT DISASSEMBLE THE INSTRUMENT
Do not disassemble the instrument.
This will void the warranty and can cause malfunctions.
Page 46
Fig.1
Fig.2
Fig.3
Fig.4