Optional Installation - Tripp-Lite SmartPro 3U Manual Del Usuario

200807051 93-2460 Smart 3U 230V OM.qxd
Quick Installation
Plug your equipment into the UPS.*
2
Plug your equipment into the UPS using the addition-
al power cord(s) that came with the UPS.
Note: Additional interconnection cords (C13 to C14) are available
from Tripp Lite. Call +1.773.869.1234 (Part # P004-006).
* Your UPS is designed to support only electronic equipment. You will
overload the UPS if the total VA ratings for all the equipment you connect
exceeds the UPS's Output Capacity. To find your equipment's VA rat-
ings, look on their nameplates. If the equipment is listed in amps, mul-
tiply the number of amps by 230 to determine VA. (Example: 1 amp ×
230 = 230 VA). If you are unsure if you have overloaded the UPS's outlets,
see "OUTPUT LOAD LEVEL" LED description.
3 Turn the UPS ON.
Press and hold the "ON/OFF/STANDBY" button for
one second. The alarm will beep once briefly after one
second has passed. Release the button.

Optional Installation

These connections are optional. Your UPS will function properly without these connections.
USB and RS-232 Serial
1
Communications
Use the included USB cable (see
cable (see ) to connect the communication port on
1b
your computer to the communication port of your
UPS. Install on your computer the Tripp Lite
PowerAlert software appropriate to your computer's
operating system. Consult your PowerAlert manual for
more information.
8/8/2008 10:10 AM
continued
) and/or DB9 serial
1a
5
Page 5
2
3
1a
1b