Important Features; Remote Control; Inserting Batteries - REVELL Control FRAM TRACTOR PLUS Manual Del Usaurio

24962
Safety instructions:
• This vehicle is suitable for children
who are at least eight years of age.
Parental supervision is required when
driving the vehicle.
• This vehicle is suitable for use indoors
and in dry outdoor areas.
• Keep your hands, face and loose
clothing away from the vehicle during
operation.
• Switch off the remote control and
vehicle when not in use.
• Remove the batteries from the re-
mote control and the vehicle not in
use.
• Always maintain visual contact with
the helicopter in order to avoid losing
control of it. Inattentive and careless
use can lead to considerable damage.
• Please keep this operating manual
safe for later use.
• The user may only operate this vehi-
cle in accordance with the instruc-
tions for use in this operating manual.
• This vehicle is suitable for use
indoors.
• This vehicle is not suitable for people
with physical or mental limitations.
• In general, it must be ensured that
the vehicle cannot injure anyone in
consideration of potential malfunctions
and defects.
• The range of the remote control is
about 10 metres. Never move the ve-
hicle outside this radius, beyond
which the vehicle cannot be cont-
rolled.
• This vehicle may not be used on
public roads!
• The product may only be repaired or
modified with approved original
10

IMporTaNT FeaTureS

Farming Line
• Agricultural vehicle with
MHz remote controls
• Very authentic design
• Fully functional
parts.Otherwise, the vehicle can be
be damaged or pose a danger.
• In order to prevent risks, always ope-
rate the vehicle from a position which
provides an easy line of retreat, if
necessary.
Remote control safety instructions:
• Rechargeable batteries must be
removed from the remote control
prior to recharging.
• Non-rechargeable batteries
may not be charged.
• Rechargeable batteries may only
be charged under the supervision
of an adult.
• Combinations of batteries of different
types or new and used batteries may
not be used.
• Only the recommended batteries
or those of an equivalent type may
be used.
• We recommend alkali manganese
batteries for the remote control.
Single-use batteries for this remote
control and other electrical devices
operated in the home can be replaced
with environmentally-friendly
rechargeable batteries.
• Batteries must be inserted with the
correct polarity (+ and -).
• Depleted batteries must be removed
from the remote control.
• The connection terminals may not be
short-circuited. Please remove the
batteries from the remote control if
it will not be used for an extended
period of time.
• As soon as the remote control no
longer functions reliably, new batte-
ries should be inserted and/or the
batteries should be charged.
Maintenance and care:
• Please only use a clean, damp cloth
to wipe off the vehicle.
• Protect the vehicle and batteries from
direct sunlight and/or direct heat.
• Never allow the remote control and
charging unit to come into contact
with water, because the electronics
will be damaged as a result.
Battery requirement for
the vehicle
Power supply:
Batteries: 3 x 1,5 V AAA battery
(not supplied)
Battery requirement for
the remote control
Power supply:
Batteries: 1 x 9 V 6LR61
E-Block battery (not supplied)
1 vehICle
1A Straight-ahead 1D Trailer coupling
trimming
1E ON/OFF switch
1B Battery
compartment
1C Screw on the
battery com-
partment

2 reMoTe CoNTrol

2A Throttle lever 2D Antenna
2B Steering wheel 2E Battery
compartment
2C Raise and lower
2F ON/OFF switch
front bucket

3 INSerTINg BaTTerIeS

Remote Control
3A Unscrew the screw on the rear side
of the remote control by turning it
anticlockwise and remove the cover.
3B Insert the 9-Volt battery with the
minus pole (large pin) facing
upwards.
3C Then fit the cover in place and close
it again by turning the screw
clockwise.
Modell
3D Unscrew the screw of the cover by
turning it anticlockwise and remove
the lid.
3E grasp the battery compartment top on
the notch and pull back.
3F Now insert three AAA batteries. For this
purpose, pay attention to the polarity
specification in the battery compartment.
3G Then place the cover in the guide rail
and re-insert. Finally, re-insert the screw
and tighten clockwise.
11