Stiga T8733 Manual Del Usuario página 10

IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREWS IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
10. Assemble parts to the bottom of the table top with Screws (#5). See Figure 7, Detail C1/C2 & Detail D1/D2.
a) Align the holes in the Leg Mounting Bracket (#20) with the holes in the table. Be sure that the bracket
is facing towards the side of the table and attach with Screws (#5) as shown in Detail C1/C2.
b) Align the holes in the two U-Support Clips (#6) with indentations in table top. Be sure that the
two U-Support Clips (#6) are positioned exactly as shown in Figure 7, Detail D1 & D2.
5
Detail C1
20
6
6
Detail D1
Note: Top U-Support Clip (#6)
faces out & Bottom (#6)
U-Support Clip faces in.
CAUTION:
5
Figure
7
10
HARDWARE NEEDED
5
#8 X 9/16 Screw
(Qty. 16)
Detail C2
20
6
6
Detail D2
Note: Top U-Support Clip (#6)
faces out & Bottom (#6)
U-Support Clip faces in.