Stiga T8733 Manual Del Usuario página 13

HARDWARE NEEDED
5
#8 X 9/16 Screw
(Qty. 29)
15. Lay out Rails (#2, #3, #23 & #33) around
edges of table top. See Figure 10.
16. Place Ball Holder end Plugs (#7) in both ends of red
Ball Holder End Rail (#4). See Figure 10 & Detail I.
17. Line up holes in rails with Indentations in table top and
secure using Screws (#5). See Figure 10 & Detail J.
Note: All Indentations
guides in table top are
small so look closely.
Stiga logo
on this side
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
7
33
33
3
CAUTION:
Detail I
4
23
R a il s
B e n d s o n
o th e r
fa c e e a c h
Figure
13
Detail J
23
Stiga logo
on this side
10
5
5
2