Stiga T8733 Manual Del Usuario página 12

HARDWARE NEEDED
24
1/4-20 X 2 1/2" Hex Head Bolt
(Qty. 2 )
13. Place Leg Assembly (from previous step) on table top.
Be sure that the offset holes in (#19) legs are
closest to the table. See Figure 9 & Detail F.
14. Attach leg Assembly (from previous step) to Bracket (#20) with
Hex Bolt (#24), Plastic Washer (#38) and Locknut (#34) as shown
in Detail G & Detail H. Tighten Lock nuts (#34) on bracket #20
first, then the nuts on Cross Tube (#25) but be careful not to
over tighten nuts as you could dent or deform the Leg.
19
shorter distance
Closest to the table
Detail F
34 38
1/4-20 Locknut
(Qty. 2)
24
12
1/4" Plastic
Washer
(Qty. 2)
Bolt (#24) goes in
the top hole of
Bracket (#20)
20
Detail G
25
Figure
9
Top View
38
34
24
19
20
Detail H