Stiga T8733 Manual Del Usuario página 8

Table top can be set on two saw horses. Although this will make
assembly easier it is not necessary to complete assembly. Always use
shipping container to protect the painted surface of the table top.
CAUTION: Make sure that the table top is secure on the
ASSEMBLY TIP
sawhorses and NEVER leave the table top unattended.
5. Lay Table Top (#1) painted side down, on a smooth, flat surface. Use the
shipping container to protect the painted surface of table top.
6. Align the "U" Support (#21) on Table Top (#1) as shown in Figure 5.
7. Align all four holes in each U-Clip (#22) with the four Indentations in table
top. Be sure that Slot in the Three U-Clips (#22) all face the same direction
toward the end of the table with no stripe and no Indentations. Secure U-
Clips (#22) with Screws (#5) as shown in Figure 5 & Detail A.
Detail A
21
Slot in
U-Clip
Note: All four holes in each U-Clip (#22) must align with four
Indentations in table top. See Detail A.
Note: Indentations in table top are small so look closely.
5
22
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-CLIPS (#22) BE
TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED INCORRECTLY, YOU WILL DO
IRREPARABLE DAMAGE TO YOUR TABLE WHEN YOU ATTEMPT TO OPEN IT TO THE
PLAYING POSITION.
IF USING AN ELECTRIC SCREWDRIVER PLEASE SET AT LOW TORQUE AND USE CAUTION
BECAUSE YOU COULD OVER-TIGHTEN THE HARDWARE AND STRIP SCREW IN WOOD
DOING IRREPARABLE DAMAGE TO THE TABLE. DO NOT OVER TIGHTEN SCREWS!
Note: All Indentations
guides in table top are
small so look closely.
1
Figure
5
Note: This end has NO stripe
8
CAUTION:
CAUTION:
HARDWARE NEEDED
5
#8 X 9/16 Screw
(Qty. 12)
21
and NO indentations.