Stiga T8733 Manual Del Usuario página 18

30
1/4-20 X 1 1/2 Phillips
Truss Head Screw
(Qty. 2)
Note: Hinges must always be positioned as shown in Detail P . With the "elbow" of the hinge
pointing towards the bottom of the table. In the correct position hinge will look like a "V".
25. Attach Hinges (#18) to Strut Tubes (#17) as shown in Figure 14 & Detail P. With
hinge positioned as shown, align hole in hinge with hole in Strut Tube and attach with
¼" Screw (#30), Plastic Washer (#38) and Locknut (#34). Plastic Washer (#38) goes
between Strut Tube and Hinge. Tighten nut securely. Repeat for other Hinge.
CAUTION: Hinges must be positioned exactly as shown or table will not
operate correctly and could be damaged.
If you want to see a video on how to attach hinges to Strut tube go to:
http://www.escaladesports.com/customer-service/instruction-videos
ATTENTION: DO NOT attach with the
"elbow" of hinge end facing up as shown
in Detail N. Attach the hinge to tube
(#17) only like shown in Detail P.
Elbow
Incorrect position
of hinge with elbow
pointing up.
CAUTION: Position hinges exactly as
shown in Detail P or table will not
operate correctly and could be damaged.
Detail P
30
18
Correct position
of hinge with elbow pointing down
In the correct position Hinge #18
will look like a "V" when attached
to Strut Tube (#17).
HARDWARE NEEDED
34
1/4-20 Locknut
(Qty. 2)
Detail O
17
34
30
38
17
Elbow
Hinge Assembly
with "elbow"
pointing down.
38
1/4" Plastic
Washer
(Qty. 2)
Or Scan QR code with
your smartphone:
Figure
17
38
18
18
DO NOT OPEN THE TABLE TO PLAYING
POSITION UNTIL BOTH TOPS ARE
INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS
BODILY INJURY OR PROPERTY DAMAGE.
14
17
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
34
18
Hinge Assembly
with "elbow"
pointing down.
30
38