Front View - Stiga T8733 Manual Del Usuario

HARDWARE NEEDED
13
3/8-16 X 2 3/4 Hex Head Bolt
(Qty. 8)
2. Lay Support Plates (#43) on Caster Beam (#8) to line up holes, the distance between middle holes to
side holes is different, see Front View of Figure 2. Attach Stop Spools (#12) and Support Plates
(#43) to side of Caster Beam without logo with Bolts (#13) and Nuts (#28) as shown in Figure 2.
DO NOT tighten completely yet this will be done in a later step. Repeat step for second Caster Beam.
Logo on
this side
13
28
3/8-16 Locknut
(Qty. 8)
8
12
43
28
Figure
10
Match holes in Support Plate (#43)
Longer
2
5
with Caster Beam (#8).
8
43
Shorter Shorter

Front View

Longer
10