Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
During operation of the equipment, it is normal that the condensation produced by the
evaporation unit will produce a certain quantity of water which will have to be evacuated. The
machines have an outlet tube for this reason on the corner of the back cover which should always
be free of any obstruction and connected to a drain.
This condensation water does not have to be treated in any special manner.
9.
PACKAGING INSPECTION.
This equipment is packaged using RECYCLABLE MATERIALS which can withstand
even the most difficult transportation conditions. Nevertheless, an inspection of the packaging
should be done upon receipt of the equipment in order to check for any damages, and to avoid
incorrect operation of the equipment.
¡WARNING!
IT IS VERY IMPORTANT TO KEEP THE PACKAGED EQUIPMENT UPRIGHT, AND THE
PACKAGING HAS BEEN SPECIFICALLY DESIGNED FOR THIS. ALWAYS MAINTAIN IT IN A
VERTICAL POSITION.
IF THE UNIT IS DAMAGED, OR THE CONSIGNMENT IS INCOMPLETE, MAKE A NOTE
OF IT ON THE CARRIER'S BILL OF LADING AND IMMEDIATELY MAKE A CLAIM TO THE
COMPANY IN CHARGE OF SHIPPING.
The package includes the following elements:
Heating and cooling swimming pool's equipment
Owner's Manual.
Warranty.
10. OPERATING CONDITIONS.
Water physical and chemical parameters must be in between:
◙ PH
◙ Residual Cl
◙ Alkalinity
◙ Solids
◙ Ca
Normal ambient conditions for operation are:
◙ Air temp. installation:
◙ Humidity:
The limits established for working conditions in order to guarantee the proper operation of
the equipment are:
◙ Minimum air temp. installation:
Temperature below this will activate the alarm.
The operating conditions will affect the output of the equipment.
Talleres del Agua will not be held responsible in this case.
7.2 to 7.8
1 to 2 ppm
80 to 125 ppm
Lower than 3000 mg/l
200 – 300 ppm
28º C
75%
18ºC
ENGLISH
34
Publicidad
Tabla de contenido
