Menu Structure In Automatic Mode; Settings In Automatic Mode - ROBBE Power Peak QUAD EQ-BID Manual Del Usaurio

6.1 Menu Structure for Automatic Mode (only Nc and NiMh)
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
'MODE'-
Button
6.2

SETTINGS IN AUTOMATIc MODE

The battery charger automatically sets the charging/discharging current and the number of
cells in automatic mode. This mode is only available for NC and NiMH battery packs. The
three operations (CHARGE; DISCHARGE; DISCHARGE->CHARGE) available for the two
types of battery are selected with the MODE button.
With the battery connected, the required operation is initiated by pressing the START but-
ton. Accompanied by an acoustic signal, the display changes over to the working display
(see Section 5.2, Page 8). The top line shows the process - Charge (L) or Discharge (E)
- and the charged-in or discharged capacity. Also, the time elapsed since the start of the
process is displayed. The bottom line shows the battery type, the current battery voltage
and the charge current. The current display alternates with the word 'auto' to indicate that
the charger is in automatic mode.
The process can be terminated by pressing the STOP button; the display for automatic
mode is then shown again. When the process is complete, the achieved final values are
shown in the display (charge/discharge capacity, process time, battery type, battery voltage
Operating Instructions
Power Peak ® Quad EQ-BID
'START'-
button
'START'-
Button
'START'-
Button
'START'-
Button
'START'-
Button
'START'-
Button
10
Order No.
8565