GreenWorks GPW 2001 Manual De Instrucciones página 19

OPERATION
N O Z Z L E
40
O
SOAP
W A R N I N G
NEVER change nozzles without engaging the lock-out on the trigger handle and NEVER point the
wand at your face or at others. The quick-connect feature contains small springs that could eject
the nozzle with some force. Failure to heed this may cause personal injury.
Turn off the pressure washer and shut off the water supply.Pull trigger to release water
pressure.
Push the collar forward so that the nozzle is secured properly. Check to see that the nozzle is
secure.
TO DISCONNECT A NOZZLE FROM THE SPRAY WAND ONCE THE CLEANING JOB IS
COMPLETE:
Turn off the pressure washer and shut off the water supply. Pull trigger to release water
pressure.
Remove the nozzle by placing hand over nozzle then pulling back the quick-connect collar.
Place nozzle in the nozzle storage area on the units folding handle.
USING THE SPRAY WAND TRIGGER
For greater control and safety, keep both hands on the trigger handle at all times.
Release the trigger to stop the flow of water through the nozzle
TO ENGAGE THE LOCK-OUT:
TO DISENGAGE THE LOCK-OUT:
Push the lock-out down and into its original position. For the most effective cleaning, the spray
nozzle should be between 8 in. and 24 in. from the surface to be cleaned. If the spray is too
close it can damage the cleaning surface.
White - Wide fan tip (40° )
The white 40 degree tip, referred to as the "fan" tip creates the
widest area of cleaning with relatively low pressure. This pressure
washer tip is best used for light or delicate cleaning applications. It
is recommended for light cleaning on wood decks and other soft or
delicate surfaces.
Black - Soap nozzle tip
The black soap degree tip, referred to as the low pressure nozzle.
This is for use with soap application.
pressure high volume for optimum
applied under high pressure with this machine.
Turbo Nozzle Tip
The nozzle rotates in a zero to 15 degree spray pattern in a circular
motion to break down tough dirt and grime. The spray pattern can
cover area of 4 to 8 inches wide, depending on a distance between
the tip and the surface being cleaned.
(See Figure 10.)
A P P L C I A I T O N
Soap is applied under low
performance. Soap cannot be
essure washer.
19