Removing/Inserting The Battery - Milwaukee M12 23GA Manual Del Operador

SPECIFICATIONS
Cat. No. ..................................................... 2540-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
Fastener Type .............................Headless pin nail*
Fastener Length ...................................1/2" - 1-3/8"
Collation Angle..................................................... 0°
Fastener Size (Diameter) .................23 GA / 0.58 mm
Magazine Capacity .............................118 to 136 nails
Recommended Ambient
Operating Temperature ......................0°F to 125°F
*Not compatible with slight headed pin nails
FUNCTIONAL DESCRIPTION
1
7
8
9
1. Trigger
2. Lock-off button
3. Handle
4. Fuel gauge
5. Belt clip
6. Magazine release
button
2 3
10 11
7. Top plate
8. Workpiece contact tip
9. Depth adjustment
10. Hex wrench
11. Workpiece contact tip
storage
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Installing/Removing Fastener Strips
WARNING
Always wear safety goggles or glasses with side
shields.
To install fastener strips:
1. Remove battery pack.
4
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
5 3. Press the magazine release button and slide
the magazine open. Place the tip of the fasten-
ers into the bottom slot of the magazine; then
lay the fasteners flat against the magazine. The
heads must fit into the grooves. WARNING!
6
Use only recommended fasteners of the correct
size, length, collation angle and head type as
indicated on the tool's nameplate. Other fasteners
could result in tool malfunction, leading to injury.
4. Slide the magazine closed.
To remove fastener strips:
1. Remove battery pack.
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
3. Press the magazine release button and slide the
magazine open.
4. Remove the fasteners.
Workpiece Contact Tips
Use workpiece contact tips to protect the workpiece.
Unclip from storage and press onto the nose. Re-
place when worn or lost.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove battery pack before
changing or removing accessories.
Always remove battery pack before
changing or removing fasteners.