Making The Electrical Connections - HAMPTON BAY 526 012 Manual Del Propietário

WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE BOT-
TOM OF THE MOUNTING PLATE MUST REST IN
THE GROOVE OF THE HANGER BALL. FAILURE
TO PROPERLY SEAT THE TAB IN THE GROOVE
COULD CAUSE DAMAGE TO WIRING.
Changing the
Downrod (Optional)
Please see the following steps on changing the
downrod prior to installation.
1. Loosen the hanger ball by removing the set
screw at the top of the downrod which holds
the hanger ball to the downrod, slide the
hanger ball down the downrod and remove
the support pin.
2. Unscrew the green groundwire from the
downrod. Release the canopy from the
downrod.
3. Remove the coupler cover from the downrod
by loosening the screw which holds coupler
cover to the downrod.
4. Remove the 6" downrod from the fan motor
by pulling out the split pin and removing the
nut, spring washer, flat washer and bolt from
the coupler.
5. Put the 18" downrod in the place where the
6" downrod was.
6. Insert the bolt through the coupler and
downrod holes. Replace flat washer and
spring washer. Screw the hexagonal nut onto
the bolt. Secure the bolt by inserting the split
pin and bending the ends to prevent it from
falling out of the holes.
7. Secure the coupler cover and downrod by
tightening the screw on the coupler cover.
8. Slide the canopy and hanger ball through
the downrod and screw the green ground-
wire onto the top of the downrod.
9. Insert the support pin in the holes at the top
of the 18" downrod. Make sure the support
pin in properly seated in the grooves in top
of the hanger ball.
10. Replace the set screw which holds hanger
ball to the downrod and tighten it firmly.
Connecting the Safety
Cable
1. Turn the J wood screw into the ceiling.
2. Place the looped end of the safety cable
onto the hook loop of the wood screw as
shown in Figure 7 and then close the hook
loop completely, or connect the safety cable
directly to the outer joist or hanging struc-
ture.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
Figure 7
5.