Hanging The Fan - HAMPTON BAY 526 012 Manual Del Propietário

Hanging the Fan

REMEMBER
to turn
er. Follow the steps below to hang your
fan properly.
NOTE: The distance from the ceiling to the
bottom of the fan blades will be approximate-
ly 14 inches for the 6 inch downrod.
NOTE: An extra 18" downrod is included that
will increase this distance to 26 inches. Please
see next page for steps on changing the down-
rod prior to installation.
Take the fan assembly out of the box. Note
that the downrod, coupler cover and canopy
are pre-assembled at the factory.
Installing Fan to
the Outlet Box
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR PERSONAL INJURY,
FAN ONLY TO AN OUTLET BOX MARKED
ACCEPTABLE FOR FAN SUPPORT AND USE
THE MOUNTING SCREWS PROVIDED WITH THE
OUTLET BOX.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting plate as
shown in Figure 5.
4.
2. Install the ceiling mounting plate on the
outlet box, by sliding the mounting plate
over the two screws provided with the outlet
off the pow-
box (Figure 5). When using close-to-ceiling
mounting, it is important that the mount-
ing plate be level. If necessary, use leveling
washers (not included) between the mount-
ing plate and the outlet box. Note that the
flat side of the mounting plate is toward the
outlet box (Figure 5).
3. Securely tighten the two mounting screws.
4. Carefully lift the assembly up to the ceil-
ing mounting plate. If using close-to-ceil-
ing mounting, hang the fan on the hook
provided by utilizing one of the holes at
the outer rim of the ceiling canopy (Fig-
ure 6). Seat the hanger ball in the mount-
ing plate socket. Make sure the tab on the
mounting plate socket is properly seated in
the groove in the hanger ball (Figure 6).
MOUNT
WHEN MOUNTING THE FAN ON A SLOPED CEIL-
ING, THE STANDARD BALL/DOWNROD MOUNT-
ING METHOD MUST BE USED. MAKE SURE THE
MOUNTING PLATE SLOTS ARE ON THE LOWER
SIDE BY SLIDING THE MOUNTING PLATE FROM
THE TOP DOWN.
Standard Mounting
THE HOOK AS SHOWN IN FIGURE 6 IS ONLY
TO BALANCE FAN WHILE ATTACHING WIR-
ING. FAILURE TO HANG AS SHOWN IN FIGURE
6 MAY RESULT IN HOOK BREAKING CAUSING
THE FAN TO FALL. HOOK MUST PASS MUST
PASS FROM INSIDE TO OUTSIDE OF CANOPY.
Figure 5
Figure 6