Mount The Camera - D-Link DCS-6010L Guía De Instalación Rápida

Mount the Camera

The DCS-6010L is suitable for mounting to a ceiling, wall or desktop using
the bracket provided. Please refer to the steps below to assist you with
mounting the camera.
Note: We suggest that you configure the camera before mounting.
Unclip the wall bracket from the
DCS-6010L by sliding the base
down.
Depending on the material of the wall or ceiling,
use proper tools to drill two holes or screws
where you marked. If the wall is made out of
concrete, drill the holes approximately 25mm
deep first, then insert the plastic anchors to
support the screws. Then affix bracket using the
screws provided.
Place the camera over the screw that is on the
bracket. Make sure to fit the screw-heads over
the big holes and slide it downward to lock
firmly. Lightly pull the base forward to make
sure that it is locked. Note: if mounting on a wall
ensure the camera is oriented with the cables
positioned to the bottom of the device.
6
Position the mounting bracket in
the desired location and mark the
surface behind it holes using the
bracket as a stencil / in pencil.
1
2
3
1
2
4
DCS-6010L