Residual Heat Indicator; Operation; Main Power Switch; Setting The Cooktop - Thermador MASTERPIECE CIT367TG Guía De Uso Y Cuidado

Residual heat indicator

The cooktop has a residual heat indicator for each
element. This indicates that an element is still hot. Do not
touch an element while the residual heat indicator is lit
up.
The following indicators are shown depending on the
amount of residual heat:
Display • : High temperature
▯
Display : Low temperature
œ
▯

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the ON l OFF touch key. An acoustic signal
sounds. The indicator located on top of the ON l OFF
touch key and the cooking zone symbols and the
functions that are available at that moment light up.
lights up next to the cooking zones. The cooktop is ready
to use.
Turning the cooktop off
Touch the ON l OFF touch key until the indicators go out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Notes
The cooktop switches off automatically when all the
▯
elements have been switched off for more than
20 seconds.
The residual heat indicator remains lit until the
elements have cooled down sufficiently.
displayed next to the corresponding element symbol.
The settings will be stored for 4 seconds after turning
▯
off the cooktop. If you turn the cooktop back on during
that time the cooktop will continue with those settings.
If you remove the cookware from the element during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the element is switched off, the residual heat
indicator will light up. Even after the cooktop has been
switched off, the residual heat indicator will stay lit for as
long as the element is still warm.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys 1
to 9.
‹ . ‹
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by .
Selecting the heat level
The cooktop must be turned on.
Select the desired element by touching the
1.
of the desired element. In the cooking zone display
.
‹ ‹
Then select the desired power level in the settings
2.
area.
1.
/ is
• œ
The power level is set.
3.
Changing the power level
Select the cooking zone and then set the required power
level in the control panel.
and is set using
†
lights up brighter.
2.
and .
@ A
symbol
ã
11