Heating Elements; Residual Heat Indicator - Thermador MASTERPIECE Serie Manual Del Usuario

Heating elements

Elements
Single element
$
The sizes of these elements can be matched to your pan size:
Dual element
ð
Triple element
ò
Bridge element
à
Always use cookware of a suitable size.

Residual heat indicator

The cooktop is equipped with a residual heat indicator
for each element. It shows you which elements are still
hot. Avoid touching the indicated elements.
If an is shown on the display, the element is still hot.
•
You could use it, for example, to keep a small quantity of
food warm or to melt a chocolate coating. As the element
continues to cool, the display changes to
goes out once the element has cooled sufficiently.
The residual heat indicator will automatically come on
after a power failure. The display lights up for
approximately 30 minutes.
10
Turning on and off
Single elements have only one size cooking surface.
Activate: Touch the key.
$
Use outer heating ring: Select the element. The
▯
heating rings are active.
Use inner heating ring: Touch the
▯
ing ring remains on.
Use outer heating ring: Select the element. The
▯
rings are active.
Use middle heating ring: Touch the
▯
ð indicator turns on. The inner and middle heating rings are active.
Use inner heating ring: Touch the
▯
heating ring remains on.
The bridge element combines two individual heating elements into one long griddle zone.
This configuration is ideal for griddles and large pans.
Note: Do not use cookware larger than 17" x 10" (432 x 254 mm).
One of the two elements that belong to the Bridge element has to be selected.
Activate: Touch the JOIN I SPLIT key. The
▯
element displays. Set the desired heat setting.
If a heat level was set on one of the elements before, this heat level will be used for the
bridge element. If two different heat levels were set on the two elements before, the bridge
element will use heat level
Change heat level: Select one of the two elements that belong to the bridge element and
▯
set the new heat level.
Deactivate: Touch the JOIN I SPLIT key.
▯
ment remains selected. Setting the heat level to
. The display
œ
ð
touch key. The
ö
ò
touch key once. The
ò
touch key again. The
ò
à indicator appears;
.
‹
appears in both displays. The front heating ele-
‹
‹
indicator turns on. The inner and outer
indicator turns off. The inner heat-
ð
indicator turns on. All three heating
indicator turns off and the
ò
indicator turns off. The inner
ð
‹ appears in both heating
does not split the bridge element.