Explanation Display Functions; Storage And Maintenance Surface; Cleaning; Troubleshooting - Tunturi Vibration plate V20 Manual Del Usuario

English
‼ NOTE
• The effective reception range of the remote
Control signal is 2.5 meters, the infrared
emission indicator of the controller should
be aligned the infrared receiving window on
the vibration plate.

Explanation Display functions

Speed
- Displays current training vibration frequency
setting.
- Range: 1 ~ 30.
‼ NOTE
• speed 1 = ± 430 Hrz p. min.
• speed 2 = ± 440 Hrz p. min.
• .....
• speed 29 = ± 710 Hrz p. min.
• speed 30 = ± 720 Hrz p. min.
Time
- Shows left time when workout.
Storage and Maintenance
Surface cleaning
⚠ WARNING
• Before cleaning, ensure the power switch is
turned off, and the attaching plug is pulled
out of the socket.
- The rubber protective top mat and covers
can be cleaned with a wet cloth containing
detergent, and the detergent should be
removed with a cloth notice
- Do not clean the vibration plate with corrosive
detergent such as benzene or thinner, as it may
cause fading, corrosion or crack on the vibration
plate's shell.
- Do not splash water into the vibration plate to
avoid short circuit.
⚠ CAUTION
• Do not carry this appliance by the power
supply cord or use cord as a handle.
8
Clean the remote controller
As wet cloth may cause malfunction of the
controller, only dry cloth can be used.
When cleaning the remote controller, it is
recommended to take out battery first.
Storage an Maintenance
- Make sure that the power switch is turned
off and the plug is removed From the power
supply.
- Clean off the dust and dirt on the vibration
plate and keep it clean and away From places
with high temperature or high humidity.
- If the vibration plate is not in use for along
period, a dust proof cover (buy it Yourself)
should be applied on the vibration plate to
prevent the entry of dust.
Change of fuse: turn the fuse base in the direction
of the arrow (counter-clockwise), and replace the
fuse with a clockwise screw back.
‼ NOTE
• Please consult after-sales department,
if malfunction can not be removed by
consumers themselves

Troubleshooting

The vibration plate can not be started
- The plug is not in place, insert the plug to
resolve.
- The power switch is in Off mode, Turn the
power switch to ON mode.
- Thermal fuse is burn, replace with a new fuse of
the same model.
Sound like phew or Da-da is heard during
working
- This is normal operational sounds produced
by the motor of from the abrasion between
mechanical parts.
Operate the controller, but the vibration
plate no action.
- The battery power of the remote is low, replace
the battery to resolve.
- The remote control is out of the receivers reach,
make sure the space in between the sender and
receiver is not blocked and not over 2,5 meters.