Adjusting The Coff Ee Length - Gaggia Milano BRERA Manual Del Usuario

The machine allows slight adjustments to
the coff ee grinder to adapt it to the kind
of coff ee used.
To make any adjustment, press and turn
the knob inside the coff ee bean hopper.
Press and turn the knob by one notch at
a time and brew 2-3 cups of coffee; this
is the only way to notice differences in
grind.
The reference marks inside the coffee
bean hopper indicate the grind setting.
There are 5 different grind settings to
choose from with the following refer-
ences:
Large Mark - Coarse Grind
Small Mark - Fine Grind.

Adjusting the Coff ee Length

The machine allows you to adjust the
amount of brewed coffee according to
your taste and/or the size of your cups.
Each time the "
pressed and released, the machine brews
a pre-set amount of coffee, as per fac-
tory settings. This amount may be repro-
grammed to your taste. Each button may
be individually programmed for a specifi c
brew setting.
As an example, the following procedure
describes the programming of the button
" ", which is normally associated with
espresso coff ee.
• Place a cup under the dispensing spout.
• Hold the "
seconds to enter the programming
mode; the "
Blinking
and the coff ee will start to be brewed;
the icon will flash during the whole
coff ee brewing cycle.
• Press the "
amount of coffee in the cup reaches
the desired level.
• 16 • • 16 •
" or " " buttons are
" button pressed for 5
" icon will blink quickly
" button again when the
At this point the button " " is pro-
grammed; each time it is pressed and
released, the machine will brew the
same amount of coff ee that was just pro-
grammed.
The same operation can be repeated for
the " " button. If the " " or "
button is pressed twice to brew coffee,
the machine will brew double the stored
quantity.
Standby
The machine is designed for energy sav-
ing. The machine automatically turns off
after 60 minutes of inactivity.
The " " button blinks when the machine
is in stand-by mode.
Note: During the turning off
phase, the machine performs
a rinse cycle, if a coff ee product has
been brewed.
Warning: When turning the machine
on after it has been turned com-
pletely off, the machine will be in
stand-by mode
To turn the machine on again simply press
the STAND-BY button (if the power but-
ton is set to "I"). In this case the machine
will go through the rinse cycle only if the
boiler is cold.
Dispensing Spout Adjust-
ment
Most cups on the market can be used
with this coff ee machine.
The height of the dispensing spout may
be adjusted to better fi t the dimensions
of the cups that you wish to use.
Manually move the dispensing spout up
or down to adjust its height by placing
your fi ngers as shown in the fi gure.
The recommended positions are:
For use with small cups;
"