HP Designjet 8000s Guia De Instalacion página 10

13. Load the tension bar (1) into the take-up reel.
The height of the take-up reel may require adjustment as it must be horizontally aligned to the media output
from the printer. Refer to the next section to verify alignment of the take-up reel height.
Take-up reel horizontal alignment
The height of the take-up reel may require adjustment as it must be horizontally aligned to the media output
from the printer. To verify alignment of the take-up reel height you need to print the take-up reel test print.
The printer will print a line across the width of the media. Use this line to check the alignment of the right
side of the take-up reel with the left side. Use the take-up reel tension bar as the horizontal reference for
alignment.
Print the take-up reel pattern on roll media to ensure that there is sufficient length to feed the media to the
tension bar on the take-up reel.
Print the take-up reel print as follows:
1. When the "Printer Ready" message appears on the Front Panel, press the
Printer offline.
2. Press the
3. In the ADJUST submenu, scroll to TEST PRINTS and press the
ENWW
SHIFT key twice and select the ADJUST menu using the
ONLINE key to take the
◄ key.
ENTER key.
Take-up reel horizontal alignment 7