HP Designjet 8000s Guia De Instalacion página 12

Only the left side of the take-up reel can be adjusted up or down.
Adjust the height of the take-up reel as follows:
1. If the take-up reel pattern on the left edge of the media is not aligned with the groove, do one of the
following:
a. If the take-up reel pattern on the left side is higher than the groove (1), turn the take-up reel height
screw clockwise to raise the left side of the take-up reel.
b. If the take-up reel pattern on the left side is lower than the groove (2), turn the take-up reel height
screw anti-clockwise to lower the left side of the take-up reel.
2. After adjusting the height, check that the pattern is aligned with the groove on the left edge of the
media. Repeat step two until both ends of the pattern are aligned with the same groove.
ENWW Take-up reel horizontal alignment 9