brennenstuhl L903 IP 55 Manual Del Usuario página 7

079612 BA_LED-Strahler L903 07.05.13 12:04 Seite 7
User Manual
Installation / Wiring
• Use the base plate to mark the drill holes in the desired location.
Drill the marked holes and ensure not damaging hidden pipes or cables.
• Feed the mains power cable through the rubber grommet.
Make sure that no water can get into the light.
• Attach the base in the desired location using suitable wall plugs and
the mounting parts included with the product.
• Observe the cable diagram for wiring and ensure proper connection
of cables and screws.
Power supply
(green/yellow)
(black or brown)
This light must be earthed!
• Attach the light to the base using the cap bolt included with the
product.
Maintenance instructions:
Do not open the LED unit. The LEDs cannot be replaced.
Any contact can damage the LEDs.
First remove the rubber gaskets over the screws for the protective
cover on the back of the light. Then loosen the screws to remove the
damaged protective cover and put a new one on. To make sure that it
is water tight, you must put the rubber gaskets back in place.
Clean light and motion detector with a damp cloth, if necessary.
Do not use any chemicals or aggressive
agents for cleaning the device.
L903 PIR IP 55 only:
Light system setting
At the bottom there are 2 control knobs.
L903 IP 55 / L903 PIR IP 55
Earth
Neutral
(blue)
Phase
Immediately replace a damaged protective cover.
Do not use the light without flawless protective cover.
To fitting
Earth
(green/yellow)
Neutral
(blue)
Phase
(black or brown)
7