Cleaning And Servicing; Troubleshooting - Bosch MMB1 Serie Instrucciones De Uso

Blender_Maxi_en-es-id-th-2zh.book Seite 8 Donnerstag, 17. Juli 2014 12:42 12
en
Attach grinder attachment by turning

it all the way clockwise. The recessed
grips on the lid must be in alignment with
the cutout on the motor unit.
Insert the mains plug.

Switch on appliance at a setting with

a high operating speed.
Note: The longer the appliance remains
switched on, the finer the ingredients
are ground.
After using the appliance:
Set the rotary switch to 0/off.

Wait until the drive comes to a standstill.
Remove mains plug.

Turn grinder attachment anti-clockwise

and remove.
Remove the cover by rotating

it in a clockwise direction.
Empty grinding cup.

Clean all parts, see "Cleaning and

servicing".

Cleaning and servicing

The appliance requires no maintenance!
Thorough cleaning guarantees a long service
life.
m
Risk of electric shock!
Never immerse the motor block in water
and never hold under running water and
do not clean in the dishwasher.
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Tips:
– Preferably clean the parts immediately
after use. This will prevent residue
from drying on and attacking the plastic
(e.g. by essential oils in herbs).
– If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.
Fig. 
Cleaning the motor block
Remove mains plug.

Wipe motor block with a damp cloth.

If required, use a little detergent.
Then wipe dry.

8
Cleaning the blender attachment
m
Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Do not clean blade holder in the dishwasher,
but under running water using a brush.
Do not leave in water!
The blender jug, smoothie insert, lid and
measuring cup are dishwasher-safe.
Tip: Pour a little water and washing-up liquid
into the attached blender.
Switch on for a few seconds. Pour out the
water and rinse the blender with clean water.
Cleaning the grinder attachment
m
Risk of injury from sharp blades!
Do not touch cutting blade with bare
hands. Clean them with a brush.
Do not clean grinding cup in the dishwasher,
but under running water using a brush.
Do not leave in water!
The lid is dishwasher-proof.

Troubleshooting

m
Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Fault:
Appliance does not start or appliance
switches off during operation.
Possible cause:
The appliance was overloaded
(e.g. blade blocked by an ingredient).
Remedial action:
Set the rotary switch to 0/off.

Wait until the drive comes to a standstill.
Remove mains plug.

Eliminate the cause of the overload.

Switch the appliance on again.

Possible cause:
Attachment has become detached.
Robert Bosch Hausgeräte GmbH