Use - Silvercrest SNM 700 A1 Manual De Instrucciones

Use

CAUTION!
Danger of injury due to sharp blades! Never grip the blade attachments by the
blades. Be careful when handling the blade attachments in order to prevent any cut
injuries.
Never insert the blade attachments into the motor unit without a shaker.
Danger of damage due to insuffi cient cooling! Never place the motor unit on
a soft surface. The ventilation openings on the side and bottom of the motor unit must
not be covered.
Danger of burns! Never fi ll the shaker with boiling-hot food or liquids! The contents
must not be hotter than 50°C.
Never operate the device when it is empty.
Do not overfi ll the containers. The shakers must not be fi lled any higher than the MAX
marking.
Always also add a little liquid to the shaker when you want to process frozen fruit or
vegetables.
Before use, make sure that all parts of the device are positioned correctly.
Do not leave the device unattended when it is in use.
Make sure that the device remains stable during operation. Always hold the motor unit
fi rmly with one hand.
The device may not be transported while it is switched on.
The storage and sprinkle lids are not suitable for the transport of liquids!
Always switch the device off and pull the mains plug from the plug socket before you
remove and / or attach a shaker.
Do not use the device for longer than 1 minute without interruption to prevent overheat-
ing. Then let the device cool down for a short while before you use it again.
1. Place the motor unit (4) on a dry, even and fi rm surface. Press the suction feet fi rmly
onto the surface.
2. Select one of the two shakers (1, 9).
3. Pour the ingredients you want into the shaker (1, 9).
4. Select a blade attachment (3, 8) and screw it clockwise onto the shaker (1, 9) (see
picture A).
NOTE: The blade attachments (3, 8) contain a sealing ring (2). This sealing ring (2)
ensures that the shaker(1, 9) does not leak during processing. Make sure that the
sealing ring (2) is correctly inserted in the groove!
5. Turn the shaker (1, 9) upside down and place the blade attachment (3, 8) into the mo-
tor unit (4). The three locking lugs on the shaker (1, 9) must be placed in the matching
recesses in the motor unit (4).
6. Connect the mains plug into a properly installed plug socket that is easily accessible.
7. To switch on the device, hold the motor unit (4) securely with one hand and rotate the
shaker (1, 9) as far as it will go clockwise with your other hand. NOTE: Do not use the
device for longer than 1 minute without interruption to prevent overheating.
40