AGA marvel MP42SS2 Instrucciones De Instalación página 23

General Information
Area Requirements
• Most of the unit's weight is at the top.
Extra care is needed when moving the unit
to prevent tipping.
• DO NOT remove protective fi lm until unit
is in operating position.
• All four leveling legs must contact the fl oor
to support and stabilize the full weight.
• DO NOT drop unit.
• Remove exterior shipping materials prior
to moving unit into home, except door
latching device.
• Use two or more people to move and
install unit. Failure to follow this instruction
can result in back or other injury.
• To avoid personal injury, wear gloves when
performing any installation procedure and
wear eye protection when cutting metal
straps.
Moving Unit
Remove shipping brackets from skid by removing four
bolts (two on each side) with a 1/2" (1.3 cm) deep-well
socket wench and a pair of pliers. Note: Tilting unit is
not required to remove shipping brackets.
Tip Over Hazard
Appliance is top heavy and tips easily when
not completely installed. Keep doors closed
until appliance is completely installed and
secured per installation instructions. Use
two or more people to move and install
appliance. Failure to do so can result in
death or serious injury.
Unpacking Unit
1. Remove top and bottom strap.
2. Remove top cap.
3. Cut carton rear approximately 1/4"
(0.6 cm) to 1" (2.5 cm) from right corner
with a utility knife extended 1/4" (0.6 cm).
4. Remove carton and exterior packaging.
Save cardboard shipping material to
protect fl oor surface when installing unit.
Remove anti-tip board and kickplate
from rear of unit.
Slip appliance dolly between unit and skid.
Remove unit from skid. Note: Use excess packaging
to protect decorative trim; also, verify that
leveling legs are up (0" adjustment).
23 23