Remote Controller And Cool/Heat Selector: Name And Function Of Each Switch And Display - Daikin LRYEQ16AY1(E) Manual De Operación

4. REMOTE CONTROLLER AND
COOL/HEAT SELECTOR: NAME
AND FUNCTION OF EACH SWITCH
AND DISPLAY
Refer to the operation manual attached with the
remote controller if a remote controller is
BRC1E51A. (This manual assumes that a
remote controller is BRC1C62.)
1. On/off button
Press the button and the system will start. Press
the button again and the system will stop.
2. Operation lamp (red)
The lamp lights up during operation.
3. Display " " (changeover under control)
It is impossible to changeover heat/cool with the
remote controller which display this icon.
4. Display " " (air flow flap)
Refer to the chapter "Operation procedure -
Adjusting the air flow direction".
5. Display "
This display shows that the ventilation unit are in
operation. (these are optional accessories)
6. Display " " (set temperature)
C
This display shows the temperature you have
set.
7. Display " " " " "
ation mode)
This display shows the current operation mode.
8. Display " " (programmed time)
This display shows the programmed time of the
system start or stop.
9. Display " " (inspection/test operation)
TEST
When the inspection/test operation button is
pressed, the display shows the mode in which
the system actually is.
English
Fig.1
" (ventilation/air cleaning)
" " " " " (oper-
10.Display "
trol)
When this display shows, the system is under
centralized control. (This is not a standard spec-
ification.)
11.Display " " (fan speed)
This display shows the fan speed you have
selected.
12.Display " " (time to clean air filter)
Refer to the operation manual of indoor unit.
13.Display " " (defrost/hot start)
Refer to the chapter "Operation procedure -
Explanation of heating operation."
14.Timer mode start/stop button
Refer to the chapter "Operation procedure - Pro-
gramming start and stop of the system with
timer."
15.Timer on/off button
Refer to the chapter "Operation procedure - Pro-
gramming start and stop of the system with
timer."
16.Inspection/test operation button
This button is only used by qualified service per-
sons for maintenance purposes.
17.Programming time button
Use this button for setting the programming start
and/or stop time.
18.Temperature setting button
Use this button for setting the desired tempera-
ture.
19.Filter sign reset button
Refer to the operation manual of indoor unit.
20.Fan speed control button
Press this button to select the fan speed of your
preference.
21.Operation mode selector button
Press this button to select the operation mode of
your preference.
22.Air flow direction adjust button
Refer to the chapter "Operation procedure -
Adjusting the air flow direction".
23.Fan only/air conditioning selector switch
Set the switch to "
" " for heating or cooling operation.
24.Cool/heat changeover switch
Set the switch to "
" " for heating operation.
25.Thermistor
It sense the room temperature around the
remote controller.
" (under centralized con-
" for fan only operation or to
" for cooling operation or to
5