Graco MySize Manual De Usuario página 23

7. Hold seat and pull front to back and
left to right at belt path to check for
secure installation (f). The child
restraint should not move side to side
or forward more than 1 inch (2.5 cm).
8. Check that the lower anchor belt stays tight and
does not slip from the tightened position. If it does
not stay tight, try another seating position or
contact Customer Service.
9. Attach tether strap hook (A) to anchor
hardware (B) and tighten adjustment belt to
remove any slack (g). Belt must lie flat and not be
twisted. Periodically check that child restraint is
securely installed; adjust if necessary.
• NOTE: Some vehicle manufacturers have lower maxi-
mum weight ratings for
consult your vehicle owner's manual or call the vehicle
manufacturer to confirm the limits on your vehicle's
LATCH anchors.
• To remove LATCH, see "Removing
Vehicle Anchor Points", p. 39.
LATCH anchors, so you must
LATCH
23
f
Tether
Do not install by this
method for a child
weighing more than
45 lb (20 kg).
from
A
B
Pull to
Tighten
g
LATCH