Publicidad
Idiomas disponibles
Idiomas disponibles
2
2
4
5
How to Assemble Your Stroller
To Open Stroller
To Assemble Rear Wheels
Remove any cardboard inserts or plastic
1
ties used to protect the product during
shipment.
Release the locking latch.
2
Unfold, making sure both side locks snap
3
into place.
Remove and discard protective plastic
1
sleeve from ends of brake assembly with
rear axle. Place stroller on floor with seat
facing down.
Position brake assembly with rear axle as
2
shown, with brake levers pointing
towards stroller handle.
Push both sides of brake assembly onto
3
rear leg tubes at the same time until
spring loaded buttons click into place.
N N O O T T E E : : Make sure that spring loaded
buttons pop through.
C C A A U U T T I I O O N N : : If spring loaded buttons DO
NOT pop through, front wheel assembly
could fall off during use.
Slide a rear wheel onto the axle then
4
slide a washer onto the axle.
Fit straight part of cotter pin through
5
hole on axle as shown.
Line up each of the tabs in the hub cap
6
with the slots in the wheel, snap hub cap
into place.
7
Repeat for second side.
5
Publicidad
