Qlima PES 7125 Instrucciones De Uso página 100

Problem
Air conditioner
does not work
Poor cooling
(heating)
effect of air
conditioner
Air conditioner
is noisy
Compressor
does not work
During cold
storage, there
is condensate
on the front
and rear plates
Never try to repair or dismantle the air conditioner yourself. Incompetent repairs
result in loss of warranty and can endanger the user.
GB
100
Possible Reason
Power is not on
Cooling, dehumidification
and heating do not start
No waiting for three minutes
after cooling heating
switching or shutdown
The doors and windows are
open, and there is a cold or
heat leak in the room. There
are other heat sources (cold
sources)
Filter screen is dirty
Air inlet or outlet blocked,
poor air circulation
Air conditioner is not put flat
- The sound comes from the
flowing of the refrigerant
inside the air conditioner
Compressor delay protection
enabled
In the cooling mode, when
the water temperature
does not reach the starting
condition of the compressor,
the water cycle is used for
cooling, and the compressor
does not start at this time.
When the air humidity is high
and the water vapor in the air
is cold, the dew will condense
on the air conditioning plate
Solution
Turn on the power
Check whether the set
temperature has been
reached
Wait for over three minutes.
Close the door or window
and remove the heat source
(cold source)
Clean or replace the filter
screen
Remove blockage
Put it on flat surface to avoid
waggling
It is normal.
Wait for more than 3
minutes and turn on the
air conditioner after the
temperature drops
When the water cycle cooling
is completed, the compressor
will be automatically started
for cooling
It is not a fault, you can
continue to use it, please
check whether you have turn
off dew removal function.