JVC KD-S35 Manual De Instalación/Conexion

KD-S35
Installation/Connection Manual
Manual de instalación/conexión
GET0563-002A
[J]
ENGLISH
PREPARATIONS
You need the installation kits which corresponds to your car.
• Mark all the check boxes ( ) to make sure you have follow the instructions and the listed parts.
Check the battery system in your car
12 V DC, NEGATIVE ground
Prepare this before installation
A B
/
Hard case/
Control panel
F
Direct connection
cable for iPod
J
Rubber cushion
INSTALLATION
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
In dash-mounting
Do the required electrical
connections.
Bend the appropriate tabs
to hold the sleeve firmly
in place.
When using the optional stay
Stay (option)
Fire wall
Dashboard
Screw (option)
ESPAÑOL
Parts list for installation and connection
C
Sleeve
G
Washer (ø5)
K
Handles
When you stand the unit, be careful
not to damage the fuse on the rear.
In a Toyota car for example, first remove the car radio and install the unit in its place.
Flat type screws
—M5 × 8 mm (M5 × 3/8")*
Bracket*
Install the unit at an angle of
less than 30˚.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?
• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
D
Trim plate
H
Lock nut (M5)
L
Remote controller
Before removing the unit, release the rear section.
When installing the unit without using the sleeve
Flat type screws
—M5 × 8 mm (M5 × 3/8")*
Pocket
Bracket*
1
© 2008 Victor Company of Japan, Limited
E
Power cord
I
Mounting bolt—
M4 × 5 mm (M4 × 1/4");
M5 × 12.5 mm (M5 × 1/2")
M
Battery
Removing the unit
* Not supplied for this unit.
0508DTSMDTJEIN
EN, SP