Virutex PEB150 Manual De Instrucciones página 14

A B
14
Using as a stationary machine
The PEB150/PEB50 portable edgebander can be used as a stationary
glue pot edgebander by placing it on the MEB50 table (optional
accessory).
Place the PEB150/PEB50 on the table. Simply fit it on and fix it in
position with the 3 screws (included.)
The MEB50 table has an auxiliary pressure roller, board support
guides at the front and back, a rear support guide which can be
extended up to 500 mm, and a removable clamp for edgebanding
straight pieces.
It is easy to edgeband straight pieces and it is also possible to
edgeband small round or shaped pieces on the table.
9. ELECTRONIC TEMPERATURE CONTROL
(Only PEB150 model)
This machine is equipped with a digital temperature display. Here
the temperature of the glue can be set infinitely variable from
120° - 200°C. First switch on the main switch of the machine. The
lower display (red) «SV» shows the currently set value. The upper
display (green) «PV» shows the current temperature of the hotmelt
adhesive in the glue pot. To change the temperature of the glue
press the «FUNC» (B) button. The red display starts flashing. If you
press this button again you can use the buttons (C) to change
the temperature at the desired level. For confirmation press the
«MODE» (A) button.
C
Once the temperature on the display has been reached,
wait 5-10 minutes for the glue to completely melt.